The main panel first page of parameters contains basic settings for the oscillator
- Set active – Set the oscillator active or inactive
- Set to modulator only – Set the oscillator to be a modulator only (no direct output generated)
- Enable the amplitude envelope
- Loop a repeating note – loop a repeating note for the oscillator so the effect of parameter changes can be heard
- The waveform – The oscillator waveform – can choose from 13 different waveforms – Silent, Sine, Square, Triangle, Sawtooth, Sinc, square rising, exponential rising, square decreasing, exponential decay, DC, Trapezoid, Noise, and custom (future feature)
- Modify the waveform – preset waveform distortions, such as square wave segmenting (values from +20 to -20, waveform changes below 0 are different from changes above 0)
- Invert the waveform
- Enable modulating the waveform
- Relative or absolute waveform modulation – modulate the waveform relative to the current value or over the entire range (-20 to +20)
- Oscillator number for modulating the waveform
- The strength of the waveform modulation
- Frequency base for the oscillator
- Current actual frequency
- Type of frequency – choose from Absolute, Relative, Offset, Relative with offset,
- Realtive semitone transposition to base frequency
- Relative ratio transposition to base frequency
- Absolute offset frequency from actual frequency – not used if the frequency type is not set to offset
- Oscillator volume – from 0 to 5000% (50x)
- Distortion strength – currently unavailable
- Feedback strength